‹

Front Bumper Reinforcement

Body and Frame › Bumper
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Front Bumper Reinforcement - Removal2 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Remove the front fascia, Front Bumper Fascia - Removal.
  2. Remove the bolt (2) and remove the jounce bumper spacer (1) from the crossmember.
Front Bumper Reinforcement - Installation3 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Install the jounce bumper spacer (1) to the slot in the crossmember.
  2. Install the bolt (2) and tighten to 8 Nm (75 in. lbs.).
  3. Install the front fascia, Front Bumper Fascia - Installation.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
REINFORCEMENT - FRONT BUMPER📷 1
1 - Crush Can 2 - Crush Can Bolt
1. Remove the front fascia. See REMOVAL. 2. Remove the bolt (2) and remove the jounce bumper spacer (1) from the crossmember.
figure
REINFORCEMENT - FRONT BUMPER📷 1
1 - Crush Can 2 - Crush Can Bolt
1. Install the jounce bumper spacer (1) to the slot in the crossmember. 2. Install the bolt (2) and tighten to 8 N.m (75 in. lbs.). 3. Install the front fascia. See INSTALLATION.
REINFORCEMENT - REAR BUMPER
figure