‹

Rear Bumper Shock Absorber

Body and Frame › Bumper
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Rear Energy Absorber - Removal3 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Remove the rear fascia, Rear Bumper Fascia - Removal.
  2. Remove the four rivets (3) from the rear absorber (2).
  3. Unsnap and remove the rear absorber (2) from the body (1).
Rear Energy Absorber - Installation3 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Position the rear absorber (2) to the body (1) then use hand pressure on the rear absorber until the plastic clips snap into place securing the rear absorber to the body.
  2. Install the four rivets (3) through the rear absorber (2) and into body (1).
  3. Install the rear fascia, Rear Bumper Fascia - Installation.