‹

Front Door Interior Handle

Body and Frame › Doors, Hood and Trunk
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Front Interior Door Handle - Removal4 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Remove the trim panel Front Door Trim Panel - Removal.
  2. Remove the interior lock rod from the interior handle.
  3. Remove the push pin (1) from the handle.
  4. Remove the spring (3) and handle (2) from the carrier.
Front Interior Door Handle - Installation4 steps
ℹ NOTE
Make sure that the push pin is seated flush with the carrier.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Install the handle (2) and spring (3) to the carrier.
  2. Install the push pin (1) into the carrier, spring and the handle.
  3. Install the interior lock rod to the interior handle (2). Make sure the lock rod is positioned properly to the carrier (1).
  4. Install the trim panel Front Door Trim Panel - Installation.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
HANDLE - INTERIOR DOOR📷 2
1. Remove the trim panel. See REMOVAL.
2. Remove the interior lock rod from the interior handle.
3. Remove the push pin (1) from the handle. 4. Remove the spring (3) and handle (2) from the carrier.
figure
figure
HANDLE - INTERIOR DOOR📷 2
1. Install the handle (2) and spring (3) to the carrier. 2. Install the push pin (1) into the carrier, spring and the handle.
NOTE: Make sure that the push pin is seated flush with the carrier.
3. Install the interior lock rod to the interior handle (2). Make sure the lock rod is positioned properly to the carrier (1).
4. Install the trim panel. See INSTALLATION.
HINGE - FRONT DOOR
figure
figure