‹

Rear Door Panel

Body and Frame › Doors, Hood and Trunk
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Rear Door Trim Panel - Removal5 steps
△ CAUTION
Do not attempt to remove the trim panel the conventional way. This door panel has hooks holding it to the door rather than push pins. Carefully follow these instructions in order to prevent unnecessary damage to the trim panel.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Remove the door handle trim bezel (3).
  2. Remove the power window switch (1) and disconnect the electrical connector (2).
  3. Using a very thin pry tool, release the cap screw covers (2) from the door trim.
  4. Remove the screws (1) from the front door trim.
  5. Carefully remove the door trim panel from the door, by lifting upward until it is removed from the door lock and the mounting attachments (3) on the carrier plate.
Rear Door Trim Panel - Installation5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Carefully install the door trim panel to the door by lifting it upward and over the door lock into the trim panel. Attach the trim panel hooks (3) to the carrier plate attachment points.
  2. Install the screws (1) to the front door trim.
  3. Install the cap screw cover (2) to the front door trim.
  4. Connect the electrical connector (2) and install the power window switch (1).
  5. Install the door handle trim bezel (3).
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
PANEL - DOOR TRIM REAR📷 2
1.   Remove the door handle trim bezel (6).
  2.   Remove the fastener (5) from the handle area of the front door trim (4).
  3.   Use a very thin pry tool to remove the cap screw covers (3) from the door trim (4).
  4.   Remove the screws (2) from the front door trim (4).
  5.   Remove the power window switch and disconnect the electrical connector.
  6.   Disengage the trim panel from the four way locator at the handle area of the trim panel, then carefully
remove the door trim panel (4) from the door (1) by lifting upward until removed from the door lock and the mounting attachments on the carrier plate.
figure
figure
PANEL - DOOR TRIM REAR📷 2
1. Carefully install the door trim panel (4) to the door (1) by lifting upward and over the door lock into the trim panel then attach the trim panel to the carrier plate attachment points. 2. Connect the electrical connector and install the power window switch. 3. Install the screws (2) to the front door trim (4). 4. Install the cap screw covers (3) to the front door trim (4). 5. Install the fastener (5) at the handle area of the front door trim (4) and tighten screw to 5.5 N.m (50 in. lbs.). 6. Install the door handle trim bezel (6).
REGULATOR - POWER WINDOW
figure
figure