‹

Rear Door Striker

Body and Frame › Doors, Hood and Trunk
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartStriker
ManufacturerCHY
OEM part #4589050AA
Price$13.60

Labor

Replace — Rear Door — One0.2 hr
Warranty 0.0 hrSkill C
Procedures
Door Latch Striker - Removal2 steps
Fig. 1
Fig. 1
  1. Remove the bolts (2) from the striker latch (3).
  2. Remove the latch striker (3) from the B-pillar (4).
Door Latch Striker - Installation3 steps
ℹ NOTE
The striker needs to be properly orientated to the B-pillar. The striker loop (1) must be installed to the inboard side of the B-pillar.
Fig. 1
Fig. 1
  1. Install the striker (3) to the B-pillar (4).
  2. Install the bolts (2) and tighten to 26 Nm (19 ft. lbs.).
  3. Adjust the door as necessary,
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
STRIKER - REAR DOOR LATCH📷 2
1. Remove the bolts (2) from the striker latch (3). 2. Remove the latch striker (3) from the B-pillar (4).
figure
figure
STRIKER - REAR DOOR LATCH📷 1
NOTE: The striker needs to be properly orientated to the B-pillar. The striker loop (1) must be installed to the inboard side of the B-pillar.
1. Install the striker (3) to the B-pillar (4). 2. Install the bolts (2) and tighten to 26 N.m (19 ft. lbs.). 3. Adjust the door as necessary, see SPECIFICATIONS.
RUN - REAR DOOR GLASS
figure