‹

Trunk / Liftgate Stop

Body and Frame › Doors, Hood and Trunk
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Bumper - Removal2 steps
Fig. 1
Fig. 1
  1. Open the lift gate.
  2. Remove the screws (2) and bumper (1) from the body.
Bumper - Installation2 steps
ℹ NOTE
Make sure the bumper is properly oriented with printed arrows pointing inboard.
Fig. 1
Fig. 1
  1. Install the bumper (1) and screws (2) to the body and tighten to 12 Nm (106 in. lbs.).
  2. Close the lift gate.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
BUMPER - LIFTGATE📷 1
1. Open the lift gate. 2. Remove the screws (2) and bumper (1) from the body.
figure
BUMPER - LIFTGATE📷 2
NOTE: Make sure the bumper is properly oriented with printed arrows pointing inboard.
1. Install the bumper (1) and screws (2) to the body and tighten to 12 N.m (106 in. lbs.). 2. Close the lift gate.
HANDLE - EXTERIOR
figure
figure