‹

Body Emblem

Body and Frame › Exterior Moulding / Trim
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Nameplate - Installation5 steps
ℹ NOTE
Before applying the emblem, clean the body surface with MOPAR(R) Super Kleen solvent or equivalent.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Remove protective cover from adhesive tape on back of emblem.
  2. Position the correct emblem properly on the body.
  3. Position the correct emblem properly on the body.
  4. Press emblem firmly to the body with the palm of hand.
  5. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun to assure adhesion. Do not exceed 52°C (120°F) when heating emblem.
Nameplate - Removal5 steps
ℹ NOTE
Exterior nameplates are attached to body panels with adhesive tape.
△ CAUTION
Use care when separating the emblem from the body surface to avoid scratching the paint.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
  2. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
  3. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun. Do not exceed 52°C (120°F) when heating emblem.
  4. Using a trim stick or equivalent, behind the emblem to separate the adhesive backing from the body.
  5. Clean adhesive residue from body with MOPAR(R) Super Clean solvent or equivalent.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
NAME PLATES - EXTERIOR📷 2
1. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
2. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
NOTE: Exterior nameplates are attached to body panels with adhesive tape.
3. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun. Do not exceed 52°C (120°F) when heating emblem.
CAUTION: Use care when separating the emblem from the body surface to avoid scratching the paint.
4. Using a trim stick C-4755 or equivalent, behind the emblem to separate the adhesive backing from the body. 5. Clean adhesive residue from body with MOPAR® Super Clean solvent or equivalent.
figure
figure
NAME PLATES - EXTERIOR📷 3
NOTE: Before applying the emblem, clean the body surface with MOPAR® Super Kleen solvent or equivalent.
1. Remove protective cover from adhesive tape on back of emblem. 2. Position the correct emblem properly on the body.
3. Position the correct emblem properly on the body. 4. Press emblem firmly to the body with the palm of hand. 5. If temperature is below 21°C (70°F) warm emblem with a heat lamp or gun to assure adhesion. Do not exceed 52°C (120°F) when heating emblem.
PANEL - A-PILLAR
figure
figure
figure