‹

Front Fender Liner

Body and Frame › Fender
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Splash Shield - Removal7 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Raise and support the vehicle, Maintenance.
  2. Remove the wheel and tire to gain access to the front wheel house liner.
  3. Carefully remove four rivets from the front fender flare molding.
  4. Remove the rivet (3) securing the wheel house liner to the lower front fascia.
  5. Remove all push pins from wheel house liner.
  6. Remove the wheel speed sensor harness from the wheel house liner.
  7. Remove front wheel house liner from front wheel house opening.
Splash Shield - Installation9 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Install front wheel house liner (1) into front wheel house opening.
  2. Install the wheel speed sensor harness to the wheel house liner.
  3. Align and install three push pins (5) into holes in the wheel house liner and fender inner wheelhouse.
  4. Align and install three push pins (2) into holes in the wheel house liner and front fascia.
  5. Install the rivet (4) connecting the splash shield to the side sill molding.
  6. Install all remaining push pins.
  7. Install the rivet (3) into the hole in the wheel house liner and lower front fascia.
  8. Install four rivets to the front fender flare molding, wheel house liner and the fender.
  9. Install wheel and tire and torque the wheel nuts to 136 Nm (100 ft. lbs.).
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
SHIELD - FRONT WHEELHOUSE SPLASH📷 2
1. Raise and support the vehicle, refer to STANDARD PROCEDURE . 2. Remove the wheel and tire to gain access to the front wheel house liner. 3. Carefully remove four rivets from the front fender flare molding.
1 - FRONT WHEEL HOUSE LINER 2 - PUSH PINS 3 - RIVET 4 - PUSH PIN 5 - PUSH PINS
  4.   Remove the rivet (3) securing the wheel house liner to the lower front fascia.
  5.   Remove all push pins from wheel house liner.
  6.   Remove the wheel speed sensor harness from the wheel house liner.
  7.   Remove front wheel house liner from front wheel house opening.
figure
figure
SHIELD - FRONT WHEELHOUSE SPLASH📷 1
1 - FRONT WHEEL HOUSE LINER 2 - PUSH PINS 3 - RIVET 4 - PUSH PIN 5 - PUSH PINS
  1.   Install front wheel house liner (1) into front wheel house opening.
  2.   Install the wheel speed sensor harness to the wheel house liner.
  3.   Align and install three push pins (5) into holes in the wheel house liner and fender inner wheelhouse.
  4.   Align and install three push pins (2) into holes in the wheel house liner and front fascia.
  5.   Install the rivet (4) connecting the splash shield to the side sill molding.
6. Install all remaining push pins. 7. Install the rivet (3) into the hole in the wheel house liner and lower front fascia.
8. Install four rivets to the front fender flare molding, wheel house liner and the fender. 9. Install wheel and tire and torque the wheel nuts to 136 N.m (100 ft. lbs.).
SHIELD - REAR WHEELHOUSE SPLASH
figure