‹

Rear Fender Liner

Body and Frame › Fender
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Splash Shield - Removal4 steps
Fig. 1
Fig. 1
  1. Remove the rear wheel flare molding, Service and Repair.
  2. Remove the two push pins securing the sill plate molding to the wheel liner and body.
  3. Remove the four push pins (3) at the wheelhouse opening (1).
  4. Remove the wheel liner (2) from the wheelhouse opening (1).
Splash Shield - Installation4 steps
Fig. 1
Fig. 1
  1. Install the wheel house liner (2) to the wheel house opening (1).
  2. Install the four push pins (3) to the wheel house liner (2).
  3. Install the two push pins securing the sill plate molding and the wheel house liner to the body.
  4. Install the rear wheel flare molding, Service and Repair.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
SHIELD - REAR WHEELHOUSE SPLASH📷 2
1.   Remove the rear wheel flare molding, see REMOVAL.
  2.   Remove the two push pins securing the sill plate molding to the wheel liner and body.
  3.   Remove the four push pins (3) at the wheelhouse opening (1).
  4.   Remove the wheel liner (2) from the wheelhouse opening (1).
figure
figure
SHIELD - REAR WHEELHOUSE SPLASH📷 1
1.   Install the wheel house liner (2) to the wheel house opening (1).
  2.   Install the four push pins (3) to the wheel house liner (2).
  3.   Install the two push pins securing the sill plate molding and the wheel house liner to the body.
  4.   Install the rear wheel flare molding, see INSTALLATION.
FULL OPEN RETRACTABLE ROOF
figure