‹

Sunroof / Moonroof Module

Body and Frame › Relays and Modules - Body and Frame
Unified entry — merged from multiple cross-listed pages in the original manual.

Labor

Replace — Control Module — Sunroof Motor2.0 hr
Warranty 0.0 hrSkill B
Sky Slider Motor0.8 hr
Warranty 0.0 hrSkill B
Replace — Control Module — Sunroof Motor2.0 hr
Warranty 0.0 hrSkill B
Sky Slider Motor0.8 hr
Warranty 0.0 hrSkill B
Procedures
Power Top Control Module - Installation6 steps
Fig. 1
Fig. 1
  1. Position the module (2) onto the power full open retractable roof assembly.
  2. Install the two mounting screws (1).
  3. Connect the electrical connectors (3).
  4. Install the headliner, Headliner - Installation.
  5. Connect the battery negative cable.
  6. Re-initialize roof assembly, Full Open Retractable Roof - Retractable Roof Initialization Procedure.
Power Top Control Module - Removal4 steps
Fig. 1
Fig. 1
  1. Disconnect and isolate the battery negative cable.
  2. Drop rear of headliner down as needed to gain access to the module, Headliner - Removal.
  3. Disconnect the electrical connectors (3) from the module.
  4. Remove the two screws (1) and separate the module (2) from the roof system.
Power Top Control Module - Installation6 steps
Fig. 1
Fig. 1
  1. Position the module (2) onto the power full open retractable roof assembly.
  2. Install the two mounting screws (1).
  3. Connect the electrical connectors (3).
  4. Install the headliner, Headliner - Installation.
  5. Connect the battery negative cable.
  6. Re-initialize roof assembly, Full Open Retractable Roof - Retractable Roof Initialization Procedure.
Power Top Control Module - Removal4 steps
Fig. 1
Fig. 1
  1. Disconnect and isolate the battery negative cable.
  2. Drop rear of headliner down as needed to gain access to the module, Headliner - Removal.
  3. Disconnect the electrical connectors (3) from the module.
  4. Remove the two screws (1) and separate the module (2) from the roof system.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
SUNROOF - MODULE/FRAME ASSEMBLY📷 3
1.   Move glass panel to fully closed position.
  2.   Disconnect and isolate negative battery cable.
  3.   If equipped, remove the overhead console, refer to REMOVAL .
  4.   Remove headliner, see REMOVAL.
  5.   Disconnect wire harness.
  6.   Disconnect the front drain tube (3) at the sunroof (2).
7. Disconnect the rear drain tube at the sunroof (1).
 8.   Remove two module bracket bolts (3) and loosen the remaining six fasteners (5).
 9.   With the aid of a helper, remove fasteners (5) attaching sunroof module assembly (2) to roof panel (1).
10.   Remove the glass panel.
11.   Remove the sunshade, see REMOVAL.
12.   Remove the drive motor. Refer to REMOVAL (POWER FULL OPEN RETRACTABLE ROOF -
figure
figure
figure
SUNROOF - MODULE/FRAME ASSEMBLY📷 1
1. Install the module brackets. 2. Install the drive motor. Refer to INSTALLATION (POWER FULL OPEN RETRACTABLE ROOF -
figure