‹

Sunroof / Moonroof Windguard

Body and Frame › Roof and Associated Components
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Wind Deflector - Removal4 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Open the sunroof glass to the full open position.
  2. Press the spring lock (1) with a small flat bladed tool and push the wind deflector (2) reward to release from the car top opening.
  3. Repeat the previous step on the opposite side.
  4. Rotate the wind deflector (1) up and release from the mounting hole (2) in the sunroof frame.
Wind Deflector - Installation3 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Position the wind deflector springs (1) into the mounting holes (2) in the sunroof frame.
  2. Rotate forward and down into position.
  3. Slide the wind deflector and spring (1) forward under the car top lip and make sure the spring lock snaps into place (2) fully.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
WIND DEFLECTOR📷 2
1.   Open the front of the roof enough to clear the wind deflector assembly (2).
  2.   Remove the center support screw.
  3.   Using an offset screwdriver, remove the two inner screws (1).
  4.   Remove the outer screws (3).
5. Lift the front of the wind deflector assembly up and separate from the rail (3).
figure
figure
WIND DEFLECTOR📷 2
1. Install the wind deflector onto the rail (3) with the tab (1) above the rail (3) and the tab (2) below the rail
(3).
2. Install the four screws (3). 3. Using an offset screwdriver, install the two inner screws (1). 4. Install the center support screw.
BUMPER - HOOD
figure
figure
DEFLECTOR - SUNROOF WIND
Release From Car Top Opening
1. Open the sunroof glass to the full open position. 2. Press the spring lock (1) with a small flat bladed tool and push the wind deflector (2) reward to release from the car top opening. 3. Repeat the previous step on the opposite side.
4. Rotate the wind deflector (1) up and release from the mounting hole (2) in the sunroof frame.
DEFLECTOR - SUNROOF WIND📷 2
1. Position the wind deflector springs (1) into the mounting holes (2) in the sunroof frame. 2. Rotate forward and down into position.
Spring Lock Snaps Into Place
3. Slide the wind deflector and spring (1) forward under the car top lip and make sure the spring lock snaps into place (2) fully.
GLASS - SUNROOF
figure
figure