Service Precautions

Safety Precautions Adhesives: ^Adhesives must comply with all federal, state, and local regulations. ^Material Safety Data Sheets (MSDS) must be available and understood before adhesives are handled ^All personnel should be instructed in the proper procedures to prevent skin contact with solvents, curing agents, and uncured base adhesives, which could cause allergic reactions or sensitization.

USE OF HEAT DURING REPAIR WARNING: Chrysler LLC engineering's position on the use of heat during collision repair is as follows: -Any body panel or frame component damaged which is to be repaired and reused, must be repaired using the " cold straightening" method. No heat may be used during the straightening process. -During rough straightening prior to panel replacement, damaged panels or frame components may be heated to assist in body/frame realignment. The application of heat must be constrained to the parts which will be replaced and not allowed to affect any other components. This "no heat" recommendation is due to the extensive use of high strength and advanced high strength steels in Chrysler LLC products. High-strength materials can be substantially and negatively affected from heat input which will not be obviously known to the repairer or consumer. Ignoring these recommendations may lead to serious compromises in the ability to protect occupants in a future collision event, reduce the engineered qualities and attributes, or decrease the durability and reliability of the vehicle. Failure to follow these instructions may be result in serious or fatal injury. This statement supersedes any previously released information by Chrysler LLC.