‹

Rear Door Window Glass Weatherstrip

Body and Frame › Weatherstrip
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Rear Door Outer Belt Molding - Installation2 steps
Fig. 1
Fig. 1
  1. Press the outer belt molding onto the outer door window flange starting at the rear and working forward.
  2. Cycle the window to make sure the window doesn't bind on the outer belt molding.
Rear Door Outer Belt Molding - Removal5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
  1. Lower window completely.
  2. Insert the outer door belt molding removal tool - between belt molding and glass at rear and then slide tool forward approximately 14 cm (5.5 in.).
  3. Push down on outer belt molding and rotate upper part of tool outward from vehicle approximately 6 - 8 cm (2.5 - 3 in.) then lift up on molding to disengage from locking tab.
  4. Repeat step 2 and 3 at 28 cm (11 in.), 43 cm (17 in.), and 57 cm (22.5 in.) from rear of door.
  5. Remove outer belt molding.
Rear Door Outer Belt Molding - Installation2 steps
Fig. 1
Fig. 1
  1. Press the outer belt molding onto the outer door window flange starting at the rear and working forward.
  2. Cycle the window to make sure the window doesn't bind on the outer belt molding.
Rear Door Outer Belt Molding - Removal5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
  1. Lower window completely.
  2. Insert the outer door belt molding removal tool - between belt molding and glass at rear and then slide tool forward approximately 14 cm (5.5 in.).
  3. Push down on outer belt molding and rotate upper part of tool outward from vehicle approximately 6 - 8 cm (2.5 - 3 in.) then lift up on molding to disengage from locking tab.
  4. Repeat step 2 and 3 at 28 cm (11 in.), 43 cm (17 in.), and 57 cm (22.5 in.) from rear of door.
  5. Remove outer belt molding.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
RUN - REAR DOOR GLASS📷 3
1. Remove the carrier plate from the door, see REMOVAL.
2. Remove the rear door glass from the window opening in the door, see REMOVAL.
3. Remove the run channel from the window opening in the door.
figure
figure
figure
RUN - REAR DOOR GLASS📷 2
1. Install the run channel to the window opening in the door.
2. Install the rear door glass to the window opening in the door, see INSTALLATION.
3. Install the carrier plate to the door, see INSTALLATION. 4. Cycle the window several times to make sure the window doesn't bind on the outer weatherstrip or run channel.
PANEL - DOOR TRIM REAR
figure
figure