‹

Air Filter Element

Engine, Cooling and Exhaust › Engine
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartAir Filter
ManufacturerCHY
OEM part #68037059AA
Price$35.00

Labor

Replace0.3 hr
Warranty 0.0 hrSkill C
Procedures
Air Cleaner - Installation4 steps
  1. Install element into housing.
  2. Position housing cover into housing locating tabs.
  3. Pry up spring clips and lock cover to housing.
  4. If any air filter, air resonator, air intake tubes or air filter housing clamps had been loosened or removed, tighten them to 5 Nm (40 in. lbs.)
Air Cleaner - Removal4 steps
ℹ NOTE
Housing removal is not necessary for element (filter) replacement.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Pry up spring clips (4) from front of housing cover (spring clips retain cover to housing).
  2. Release housing cover from 4 locating tabs located on rear of housing, and remove cover.
  3. Remove air cleaner element (filter) from housing.
  4. Clean inside of housing before replacing element.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
CLEANER-AIR ELEMENT📷 2

Removal

1 - AIR INTAKE HOSE 2 - HOSE CLAMP 3 - COVER 4 - CLIPS (2)
Housing removal is not necessary for element (filter) replacement.
1
Pry up spring clips (4) from front of housing cover (spring clips retain cover to housing). See Fig. 47.
2
Release housing cover from 4 locating tabs located on rear of housing, and remove cover.
3
Remove air cleaner element (filter) from housing.
4
Clean inside of housing before replacing element.

Installation

1
Install element into housing.
2
Position housing cover into housing locating tabs.
3
Pry up spring clips and lock cover to housing.
If any air filter, air resonator, air intake tubes or air filter housing clamps had been loosened or removed, tighten them to 5 N.m (40 in. lbs.) CYLINDER HEAD - LEFT
figure
figure