‹

Cargo Lamp Bulb

Lighting and Horns › Cargo Lamp
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Cargo Lamp Bulb - Installation4 steps
△ CAUTION
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
Fig. 1
Fig. 1
  1. Align the ends of the bulb (3) with the two bulb holders within the cargo lamp housing (1).
  2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
  3. Swing the notched end of the lens (4) up into position against the housing, then press upward on the lens firmly and evenly until it snaps into the housing.
  4. Reconnect the battery negative cable.
Cargo Lamp Bulb - Removal5 steps
Fig. 1
Fig. 1
  1. Disconnect and isolate the battery negative cable.
  2. Insert the tip of a small flat-bladed screwdriver into the notch on one side of the cargo lamp between the lens (4) and the lamp housing (1).
  3. Gently pry the notched edge of the lens downward until it unsnaps from the housing.
  4. Swing the notched end of the lens downward far enough to access the bulb (3).
  5. Carefully unsnap the bulb from the two bulb holders within the cargo lamp housing.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
CARGO LAMP BULB📷 1
1. Disconnect and isolate the battery negative cable. 2. Insert the tip of a small flat-bladed screwdriver into the notch on one side of the cargo lamp between the lens (4) and the lamp housing (1). 3. Gently pry the notched edge of the lens downward until it unsnaps from the housing. 4. Swing the notched end of the lens downward far enough to access the bulb (3). 5. Carefully unsnap the bulb from the two bulb holders within the cargo lamp housing.
figure
CARGO LAMP BULB📷 1
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
1. Align the ends of the bulb (3) with the two bulb holders within the cargo lamp housing (1). 2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place. 3. Swing the notched end of the lens (4) up into position against the housing, then press upward on the lens firmly and evenly until it snaps into the housing. 4. Reconnect the battery negative cable.
COURTESY LAMP
figure