‹

Canister Purge Solenoid

Powertrain Management › Emission Control Systems
Unified entry — merged from multiple cross-listed pages in the original manual.

Labor

Replace — Purge Solenoid0.4 hr
Warranty 0.0 hrSkill B
Procedures
Evap Purge Solenoid - Removal3 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Lift the solenoid assembly (1) from the tongue-type bracket (2).
  2. Disconnect electrical connector (5).
  3. Disconnect quick-connect fittings (3) and (4) from solenoid.
Evap Purge Solenoid - Installation4 steps
Fig. 1
Fig. 1
  1. Connect quick-connect fittings (3) and (4) to solenoid.
  2. Connect electrical connector (5).
  3. Push solenoid assembly (1) onto the tongue-type bracket (2).
  4. The vapor/vacuum lines and hoses must be firmly connected. Also check the vapor/vacuum lines at the ESIM switch and filter for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
DUTY CYCLE EVAP CANISTER PURGE SOLENOID📷 1
The EVAP canister purge solenoid (1) is located near the battery (2).
Connector
1. Lift the solenoid assembly (1) from the tongue-type bracket (2). 2. Disconnect electrical connector (5). 3. Disconnect quick-connect fittings (3) and (4) from solenoid.
figure
DUTY CYCLE EVAP CANISTER PURGE SOLENOID📷 2
Connector
  1.   Connect quick-connect fittings (3) and (4) to solenoid.
  2.   Connect electrical connector (5).
  3.   Push solenoid assembly (1) onto the tongue-type bracket (2).
  4.   The vapor/vacuum lines and hoses must be firmly connected. Also check the vapor/vacuum lines at
the ESIM switch and filter for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
CAP-FUEL FILLER
figure
figure