‹

Evaporative Emission Control Canister

Powertrain Management › Emission Control Systems
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartVapor Canister
ManufacturerCHY
OEM part #5147071AC
Price$119.00

Labor

Replace — Vapor Canister0.4 hr
Warranty 0.0 hrSkill B
Procedures
Installation7 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Position canister locating pins (1) into bracket (2).
  2. Install nut/bolt (1) at front of canister mounting bracket (2).
  3. Clean dirt or debris from canister vacuum lines.
  4. Connect electrical connector (3) to ESIM switch (2).
  5. Connect rubber hose (6) to ESIM switch (2).
  6. Connect quick-connect fitting (5) to EVAP canister.
  7. Lower vehicle.
Removal7 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Raise and support vehicle.
  2. Clean dirt or debris from canister vacuum lines.
  3. Disconnect electrical connector (3) at ESIM switch (2).
  4. Disconnect rubber hose (6) from ESIM switch (2).
  5. Disconnect quick-connect fitting (5) at EVAP canister.
  6. Remove nut/bolt (1) at front of canister mounting bracket (2).
  7. To remove canister, pull straight forward until pins (1) have cleared bracket (2).
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
CANISTER - VAPOR📷 1
—
figure
EVAP CANISTER📷 6
A maintenance free, EVAP canister is used on all vehicles. The EVAP canister is filled with granules of an activated carbon mixture. Fuel vapors entering the EVAP canister are absorbed by the charcoal granules.
Fuel tank pressure vents into the EVAP canister. Fuel vapors are temporarily held in the canister until they can be drawn into the intake manifold. The duty cycle EVAP canister purge solenoid allows the EVAP canister to be purged at predetermined times and at certain engine operating conditions.
The EVAP canister is also to be considered as part of the ORVR system.

Removal

Connect Fitting & Rubber Hose
The EVAP canister (1) is located under the vehicle behind the plastic splash shield (4) used for the left/rear tire. The ESIM switch (2) is attached to the EVAP canister.
1
Raise and support vehicle.
2
Clean dirt or debris from canister vacuum lines.
3
Disconnect electrical connector (3) at ESIM switch (2).
4
Disconnect rubber hose (6) from ESIM switch (2).
5
Disconnect quick-connect fitting (5) at EVAP canister.
6
Remove nut/bolt (1) at front of canister mounting bracket (2).
7
To remove canister, pull straight forward until pins (1) have cleared bracket (2).

Installation

1
Position canister locating pins (1) into bracket (2).
2
Install nut/bolt (1) at front of canister mounting bracket (2).
Quick-Connect Fitting & Rubber Hose
3
Clean dirt or debris from canister vacuum lines.
4
Connect electrical connector (3) to ESIM switch (2).
5
Connect rubber hose (6) to ESIM switch (2).
6
Connect quick-connect fitting (5) to EVAP canister.
7
Lower vehicle.
figure
figure
figure
figure
figure
figure