Detailed components
🔧
Control Module
8 procedures
🔧
Fluid Pressure Sensor/Switch
7 procedures
🔧
Four Wheel Drive Selector Switch
2 procedures · Labor
🔧
Gear Sensor/Switch
9 procedures
🔧
Overdrive Solenoid
4 procedures
🔧
Pressure Regulating Solenoid
7 procedures
🔧
Shift Indicator - A/T
2 procedures
🔧
Shift Solenoid
4 procedures
🔧
Transfer Case Actuator
7 procedures · Labor
🔧
Transmission Control System Relay
2 procedures
🔧
Transmission Speed Sensor
8 procedures
🔧
Transmission Temperature Sensor/Switch
2 procedures
Quick reference
Control Module, Transfer Case
Labor
Labor
Replace — Control Module0.6 hr
Transmission Control Systems
1 procedure
Transmission Control Systems: Testing and Inspection
ℹ NOTE
Vehicle must remain in Overdrive for at least 3.0 seconds.ℹ NOTE
If all the PRNDL lights box individually then the error was cleared.- With the scan tool, erase Transmission DTCs.
- Cycle the ignition off, then start the vehicle.
- Firmly apply the brakes and shift into Overdrive.
- With the brakes firmly applied, shift slowly through all gears (PRNDL) as least three times, pausing momentarily in each gear.
- Shift into park and turn the ignition off to the lock position.
- With the ignition on, engine not running, using the scan tool, read DTCs. Does the DTC P0706 reset, or do all the PRNDL indicators remain boxed in park or neutral? Yes -Perform the diagnostic procedure for P0706-TRANSMISSION RANGE SENSOR RATIONALITY. No -Test Complete. -Perform 42RLE TRANSMISSION VERIFICATION TEST. 42RLE Transmission Verification Test
Transmission Position Sensor/Switch, A/T
Labor
Labor
Replace — Range Sensor1.7 hr