‹

Main Relay (Computer/Fuel System)

Relays and Modules › Relays and Modules - Powertrain Management
Unified entry — merged from multiple cross-listed pages in the original manual.

Labor

Replace — Auto Shutdown Relay0.3 hr
Warranty 0.0 hrSkill B
Replace — Auto Shutdown Relay0.3 hr
Warranty 0.0 hrSkill B
Procedures
Auto Shutdown Relay - Removal4 steps
ℹ NOTE
The ASD relay is located in the Totally Integrated Power Module (TIPM) (1). The TIPM is located in the engine compartment near the left inner fender (2). Refer to label on TIPM cover for relay location.
Fig. 1
Fig. 1
  1. Remove TIPM cover.
  2. Remove relay from TIPM.
  3. Check condition of relay terminals and TIPM connector terminals for damage or corrosion. Repair if necessary before installing relay.
  4. Check for pin height (pin height should be the same for all terminals within the TIPM connector). Repair if necessary before installing relay.
Auto Shutdown Relay - Installation3 steps
Fig. 1
Fig. 1
  1. Refer to TIPM cover for ASD relay location.
  2. Install relay to TIPM (1).
  3. Install cover to TIPM.
Auto Shutdown Relay - Removal4 steps
ℹ NOTE
The ASD relay is located in the Totally Integrated Power Module (TIPM) (1). The TIPM is located in the engine compartment near the left inner fender (2). Refer to label on TIPM cover for relay location.
Fig. 1
Fig. 1
  1. Remove TIPM cover.
  2. Remove relay from TIPM.
  3. Check condition of relay terminals and TIPM connector terminals for damage or corrosion. Repair if necessary before installing relay.
  4. Check for pin height (pin height should be the same for all terminals within the TIPM connector). Repair if necessary before installing relay.
Auto Shutdown Relay - Installation3 steps
Fig. 1
Fig. 1
  1. Refer to TIPM cover for ASD relay location.
  2. Install relay to TIPM (1).
  3. Install cover to TIPM.