‹

Starter Relay

Relays and Modules › Relays and Modules - Starting and Charging
Unified entry — merged from multiple cross-listed pages in the original manual.

Labor

Replace0.3 hr
Warranty 0.0 hrSkill B
Procedures
Starter Relay - Installation3 steps
Fig. 1
Fig. 1
  1. Refer to Power Distribution Center (PDC) cover for starter relay location.
  2. Install relay to PDC (1).
  3. Install cover to PDC.
Starter Relay - Removal4 steps
Fig. 1
Fig. 1
  1. Remove PDC cover.
  2. Remove relay from PDC.
  3. Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.
  4. Check for pin height (pin height should be the same for all terminals within the PDC connector). Repair if necessary before installing relay.