‹

Crankshaft Position Sensor

Sensors and Switches › Sensors and Switches - Powertrain Management
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartCrankshaft Position Sensor
ManufacturerCHY
OEM part #56044180AC
Price$42.20
PartCrankshaft Position Sensor
ManufacturerCHY
OEM part #56044180AC
Price$42.20

Labor

Replace — Crankshaft Position Sensor0.6 hr
Warranty 0.0 hrSkill B
Replace — Crankshaft Position Sensor0.6 hr
Warranty 0.0 hrSkill B
Procedures
Crankshaft Position Sensor - Installation6 steps
△ CAUTION
Before tightening sensor mounting bolt (1), be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Clean out machined hole in engine block.
  2. Apply a small amount of engine oil to sensor o-ring (3).
  3. Install sensor (2) into engine block with a slight rocking and twisting action.
  4. Install mounting bolt (1).
  5. Connect electrical connector to sensor.
  6. Lower vehicle.
Crankshaft Position Sensor - Removal5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Raise vehicle.
  2. Disconnect sensor electrical connector.
  3. Remove sensor mounting bolt (1).
  4. Carefully twist sensor from cylinder block.
  5. Check condition of sensor o-ring (3).
Crankshaft Position Sensor - Installation6 steps
△ CAUTION
Before tightening sensor mounting bolt (1), be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Clean out machined hole in engine block.
  2. Apply a small amount of engine oil to sensor o-ring (3).
  3. Install sensor (2) into engine block with a slight rocking and twisting action.
  4. Install mounting bolt (1).
  5. Connect electrical connector to sensor.
  6. Lower vehicle.
Crankshaft Position Sensor - Removal5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Raise vehicle.
  2. Disconnect sensor electrical connector.
  3. Remove sensor mounting bolt (1).
  4. Carefully twist sensor from cylinder block.
  5. Check condition of sensor o-ring (3).