‹

Fuse

Starting and Charging › Power and Ground Distribution
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
IOD Fuse - Removal3 steps
ℹ NOTE
When removing or installing the IOD fuse, it is important that the ignition switch be in the Off position. Failure to place the ignition switch in the Off position can cause the radio display to become scrambled when the IOD fuse is installed. Removing and installing the IOD fuse again with the ignition switch in the Off position will usually correct the scrambled radio display condition.
  1. Turn the ignition switch to the Off position.
  2. Open the cover of the Totally Integrated Power Module (TIPM).
  3. Pull up fuse J13 until it is in the pre-stage position from the TIPM.
IOD Fuse - Installation3 steps
△ CAUTION
It is extremely important that the Ignition Off Draw (IOD) fuse is fully seated into the Totally Integrated Power Module (TIPM) fuse cavity. Failure to install the fuse correctly could result in erratic electrical systems behavior.
  1. Open the TIPM cover.
  2. Insert fuse J13 into the TIPM. Push fuse down until it is fully seated in the TIPM cavity.
  3. Close the TIPM cover.