‹

Cross-Member

Steering and Suspension › Suspension
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Crossmember - Removal — Front Suspension9 steps
ℹ NOTE
Use a grease marker to mark the lower control arm cam bolts with reference points to ease with the wheel alignment.
ℹ NOTE
Using a grease pencil or equivalent, mark the location of the engine support cradle.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
Fig. 5
Fig. 5
Fig. 6
Fig. 6
Fig. 7
Fig. 7
Fig. 8
Fig. 8
Fig. 9
Fig. 9
Fig. 10
Fig. 10
Fig. 11
Fig. 11
  1. Install engine support tool or equivalent.
  2. Raise and support the vehicle.
  3. Remove the lower control arms, Front Lower Control Arm - Removal.
  4. Remove the stabilizer bar, Front Stabilizer Bar - Removal.
  5. Remove the front axle, if equipped, Removal.
  6. Remove the power steering rack, Steering Gear - Removal.
  7. Loosen the engine mount through bolts.
  8. Support the engine cradle with a suitable lifting device.
  9. Remove the engine cradle support bolts and remove the engine cradle.
Crossmember - Removal — Transmission5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Remove the transmission skid plate. Transmission
  2. Remove the transfer case skid plate. Transfer Case
  3. Support the transmission with a suitable lifting device.
  4. Remove the four transmission mount nuts from the crossmember.
  5. Remove the six bolts (2) and remove the crossmember (1).
Crossmember - Installation — Front Suspension8 steps
ℹ NOTE
Refer to the reference marks made during cradle removal procedure and align the cradle to those marks.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
Fig. 5
Fig. 5
Fig. 6
Fig. 6
Fig. 7
Fig. 7
Fig. 8
Fig. 8
  1. Place the cradle on a suitable lifting device, then raise the engine cradle into the vehicle while lining up the engine mount through bolts.
  2. Install the cradle mounting bolts and tighten the front bolts to 122 Nm (90 ft. lbs.) and tighten the rear bolts to 115 Nm (85 ft. lbs.).
  3. Tighten the engine mount through bolts to 88 Nm (65 ft. lbs.).
  4. Install the steering gear, Steering Gear - Installation.
  5. Install the front axle, if equipped, Installation.
  6. Install the stabilizer bar, Front Stabilizer Bar - Installation.
  7. Install the lower control arms, Front Lower Control Arm - Installation.
  8. Lower the vehicle and remove the engine support tool.
Crossmember - Installation — Transmission5 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Install the crossmember and six bolts and tighten the bolts to 47 Nm (35 ft. lbs.).
  2. Install four transmission mount nuts and tighten to 88 Nm (65 ft. lbs.).
  3. Remove the transmission lifting device.
  4. Install the transfer case skid plate. Transfer Case
  5. Install the transmission skid plate. Transmission