‹

Shift Interlock Cable

Transmission and Drivetrain › Automatic Transmission/Transaxle
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartInterlock Cable
ManufacturerCHY
OEM part #52125305AD
Price$38.35

Labor

Replace0.6 hr
Warranty 0.0 hrSkill B
Procedures
Park Lock Cable - Removal7 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
  1. Place ignition key in the ON position.
  2. Lower the steering column.
  3. With the ignition switch in the "RUN" position depress the park-interlock cable locking tab (2), located on top of the cable connector at the steering column and pull the cable straight out.
  4. Remove the park-interlock cable from steering column.
  5. Remove the floor console and related trim.
  6. Release the park-interlock cable from any remaining clips.
  7. Remove park-interlock cable from the vehicle.
Park Lock Cable - Installation9 steps
ℹ NOTE
The gearshift cable must be secured into position and properly adjusted before the installation of the Park-Interlock Cable.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
  1. Place ignition key in the ON position.
  2. Push the park-interlock cable (3) straight into the square mounting hole in the steering column until cable snaps in place.
  3. Snap park-interlock cable tie strap into hole in steering column tube.
  4. Route cable to the shifter mechanism.
  5. Install the cable end fitting into shifter lever (1).
  6. Snap cable adjuster ears into floor shifter bracket.
  7. Place the ignition key cylinder in the LOCK position.
  8. Test the park-interlock cable operation.
  9. Install the floor console and related trim.
Shift Interlock Cable: Testing and Inspectionreference
Fig. 1
Fig. 1
PARK LOCK CABLE
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
INTERLOCK CABLE.
"Key in ON (3) position. The The shifter will not move out of shifter can move out of PARK Replace the shifter assy. Refer to PARK with the override activated without depressing the brake SHIFT MECHANISM. " pedal"
"Key in ON (3) position. The1. Misadjusted Park Lock cable.1.Readjust the park interlock cable
shifter cannot be moved out of"
PARK with the brake pedal2. The shifter will move out of2. If the shifter solenoid get
depressed."PARK with the override activated. powered with brake pedal
depressed than change the shifter assy. - If the shifter solenoid does not get powered when brake pedal is depressed, verify the electrical system."