‹

Front Door Window Glass

Windows and Glass › Windows
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Front Door Glass - Installation5 steps
ℹ NOTE
The glass should snap into place. Make sure the glass is secure to the liftplate by pulling up on the glass to verify.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
Fig. 5
Fig. 5
  1. Insert the narrow end of the glass (1) into the door through the opening between the inner and outer panels (2). Then engage the front edge of the glass into the front portion of the glass run weatherstrip before rotating the back edge of the glass rearward into the B-pillar portion of the weatherstrip.
  2. Connect the door glass (1) to the window regulator (2) by sliding the glass down into the liftplate.
  3. Apply the adhesive tape (1) to the inspection cover in the door carrier plate.
  4. Install the inner door weatherstrip Front Door Inner Belt Weatherstrip - Installation.
  5. Install the trim panel (4) to the door Front Door Trim Panel - Installation.
Front Door Glass - Removal7 steps
△ CAUTION
Do not attempt to remove the trim panel the conventional way. This door panel has hooks holding it to the door rather than push pins. Carefully follow these instructions in order to prevent unnecessary damage to the trim panel.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
Fig. 5
Fig. 5
  1. Remove the trim panel Front Door Trim Panel - Removal.
  2. Remove the inner door weatherstrip Front Door Inner Belt Weatherstrip - Removal.
  3. Remove the tape covering the access hole (1) on the carrier plate. Access the window regulator liftplate through the hole in the carrier plate.
  4. With the aid of an assistant push down the door glass (1) and using a flat bladed tool or equivalent, release the tab on the window regulator liftplate (2).
  5. Carefully lift up on the glass until it clears the tab and remove the flat bladed tool.
  6. Continue lifting up on the glass (1) and rotate the top of the glass forward in the door channel (2).
  7. Remove the glass (1) from the upper door panels (2).