‹

Quarter Window Glass

Windows and Glass › Windows
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Quarter Glass - Removal3 steps
Fig. 1
Fig. 1
  1. Remove the quarter trim panel as necessary to gain access to the glass seal from the inside, Quarter Trim Panel - Removal.
  2. Cut urethane bonding from around quarter glass (1) using a suitable sharp cold knife. A pneumatic cutting device can be used if available.
  3. Remove glass from vehicle.
Quarter Glass - Installation9 steps
△ CAUTION
Open a window before installing glass. This will avoid pressurizing the passenger compartment. If a door or swing gate flip-up glass is slammed before urethane is cured, water leaks can result.
Fig. 1
Fig. 1
  1. Clean inside of glass with Mopar(R) Glass Cleaner and lint-free cloth.
  2. Apply PVC (vinyl) primer 25 mm (1 in.) wide around edge of glass. Wipe with clean/dry lint-free cloth.
  3. Apply fence primer around edge of fence. Allow at least eighteen minutes drying time.
  4. Apply a 10 mm (0.4 in.) bead of urethane around window vinyl border location.
  5. Install the adhesive backed spacers (2) to the upper part of the quarter glass (1).
  6. Install the spacers (3) to the lower part of the quarter glass (1).
  7. Position quarter glass (1) into window opening and lock clips into place.
  8. Install the quarter trim panel if removed, Quarter Trim Panel - Installation.
  9. After urethane has cured, water test quarter glass to verify repair.