‹

Rear Bumper Reinforcement

Body and Frame › Bumper
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Rear Bumper Reinforcement - Removal4 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Remove the rear bumper fascia foam Rear Energy Absorber - Removal.
  2. Remove the four screws (4) from the crossmember support (3).
  3. Remove the crossmember (3) from the body (2).
  4. Remove the U - Nuts (1) from the body (2).
Rear Bumper Reinforcement - Installation4 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Install the U - nuts (1) to the body (2).
  2. Install the crossmember support (3) to the body (2).
  3. Install the four screws (4) to the crossmember support (3) and tighten to 7 Nm (5 ft. lbs.).
  4. Install the rear bumper fascia foam , Rear Energy Absorber - Installation.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
REINFORCEMENT - REAR BUMPER📷 2
1. Remove the rear bumper fascia foam. See REMOVAL.
1 - U - Nut 2 - Body 3 - Crossmember Support 4 - Screw
2. Remove the four screws (4) from the crossmember support (3). 3. Remove the crossmember (3) from the body (2). 4. Remove the U - Nuts (1) from the body (2).
figure
figure
REINFORCEMENT - REAR BUMPER📷 1
1 - U - Nut 2 - Body 3 - Crossmember Support 4 - Screw
  1.   Install the U - nuts (1) to the body (2).
  2.   Install the crossmember support (3) to the body (2).
  3.   Install the four screws (4) to the crossmember support (3) and tighten to 7 N.m (5 ft. lbs.).
  4.   Install the rear bumper fascia foam. See INSTALLATION.
figure