‹

Front Door Window Motor

Body and Frame › Doors, Hood and Trunk
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartRight
ManufacturerCHY
OEM part #68033484AB
Price$78.10
PartLeft
ManufacturerCHY
OEM part #68033485AB
Price$76.20
PartRight
ManufacturerCHY
OEM part #68004590AA
Price$101.00
PartLeft
ManufacturerCHY
OEM part #68004591AA
Price$95.45

Labor

Replace — Front Door — One Side0.9 hr
Warranty 0.0 hrSkill B
Procedures
Window Regulator Motor - Installation7 steps
ℹ NOTE
The power window motor may need to actuated momentarily to line up the gear in the drive assembly with the regulator.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Connect the power window motor electrical connector to the motor electrical connector receptacle (3).
  2. Position the power window motor and gear assembly (2) on the carrier plate (1) aligning the drive gear with the regulator.
  3. If necessary, temporarily connect the window switch assembly and battery to actuate the motor.
  4. Install and tighten the three fasteners (4) that secure the power window motor and gear assembly to the carrier plate.
  5. Reinstall the door interior trim panel (2), Front Door Trim Panel - Installation or Rear Door Trim Panel - Installation for the appropriate procedure.
  6. Connect the negative battery cable.
  7. Perform the Clear/Relearn procedure. Programming and Relearning
Window Regulator Motor - Removal6 steps
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
  1. Partially raise or lower the door glass to relieve tension on motor and cables. Secure the glass as necessary.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the door interior trim panel (2), Front Door Trim Panel - Removal or Rear Door Trim Panel - Installation for the appropriate procedure.
  4. Disconnect the power window motor electrical connector from the motor electrical connector receptacle (3).
  5. Remove the three fasteners (4) that secure the power window motor and gear assembly (2) to the carrier plate (1).
  6. Using a flat bladed tool, lightly pry the cable drive (1) away from the motor (2) and remove the motor and gear assembly.
Front Door Window Motor: Testing and Inspection3 steps
  1. Disconnect and isolate the battery negative cable. Remove the trim panel from the door with the inoperative power window.
  2. Unplug the power window motor wire harness connector. Apply 12 volts across the motor terminals to check its operation in one direction. Reverse the connections across the motor terminals to check the operation in the other direction. If the window is in the full up or full down position, the motor will not operate in that direction by design. If OK, repair the circuits from the power window motor to the power window switch as required. If not OK, replace the inoperative motor.
  3. If the motor operates in both directions, check the operation of the window glass and lift mechanism through its complete up and down travel. There should be no binding or sticking of the window glass or lift mechanism through the entire travel range. If not OK, check the window glass, tracks, and regulator for sticking, binding, or improper adjustment.