‹

Sun Visor

Body and Frame › Interior Moulding / Trim
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Visor Support - Installation2 steps
Fig. 1
Fig. 1
  1. Position the sun visor support (2) on the headliner (3) and install the screw that secures the support to the roof panel.
  2. Engage the sun visor (1) and sun visor support.
Visor - Removal2 steps
Fig. 1
Fig. 1
  1. Remove the two screws and remove the sun visor (2) from the headliner/roof assembly (1).
  2. If equipped, disconnect the illuminated vanity mirror wire harness connector.
Visor Support - Removal2 steps
Fig. 1
Fig. 1
  1. Disengage the sun visor (1) from the sun visor support (2).
  2. Remove the screw that secures the support to the roof panel and remove the support from the headliner (3).
Visor - Installation2 steps
Fig. 1
Fig. 1
  1. If equipped, connect the illuminated vanity mirror wire harness connector.
  2. Position the sun visor (2) to the headliner/roof (1) and install the screws. Tighten the screws to 2 Nm (20 in. lbs.).
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
SUPPORT - SUN VISOR📷 1
1. Disengage the sun visor (1) from the sun visor support (2). 2. Remove the screw that secures the support to the roof panel and remove the support from the headliner (3).
figure
SUPPORT - SUN VISOR📷 1
1. Position the sun visor support (2) on the headliner (3) and install the screw that secures the support to the roof panel. 2. Engage the sun visor (1) and sun visor support.
VISOR - SUN
figure
VISOR - SUN📷 1
1. Remove the two screws and remove the sun visor (2) from the headliner/roof assembly (1). 2. If equipped, disconnect the illuminated vanity mirror wire harness connector.
figure
VISOR - SUN📷 1
1. If equipped, connect the illuminated vanity mirror wire harness connector. 2. Position the sun visor (2) to the headliner/roof (1) and install the screws. Tighten the screws to 2 N.m (20 in. lbs.).
BUMPER - LIFTGATE
figure