‹

Parking Assist Control Module

Relays and Modules › Relays and Modules - Accessories and Optional Equipment
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartModule
ManufacturerCHY
OEM part #56054151AE
Price$125.00

Labor

Replace — Control Module0.4 hr
Warranty 0.0 hrSkill B
Procedures
Park Assist Module - Removal5 steps
Fig. 1
Fig. 1
  1. Disconnect and isolate the battery negative cable.
  2. Partially remove the trim from the right quarter inner panel to access the park assist module (2), which is located above and behind the right rear wheel house, forward of the D-pillar. Quarter Trim Panel - Removal.
  3. Disconnect the two body wire harness connectors (4) from the park assist module connector receptacles.
  4. Remove the three plastic push-in fasteners (3) that secure the module to the right quarter inner panel (1).
  5. Remove the module from the right quarter inner panel.
Park Assist Module - Installation5 steps
Fig. 1
Fig. 1
  1. Position the park assist module (2) to the right quarter inner panel (1) behind and above the right rear wheel house, forward of the D-pillar.
  2. Secure the module to the right quarter inner panel using three plastic push-in fasteners (3).
  3. Reconnect the two body wire harness connectors (4) to the module connector receptacles.
  4. Reinstall the trim onto the right quarter inner panel.Quarter Trim Panel - Installation.
  5. Reconnect the battery negative cable.
Park Assist Module - Descriptionreference
Fig. 1
Fig. 1
DESCRIPTION The Park Assist Module (3) is secured with three push-in plastic fasteners through three mounting tabs (2) integral to the module housing to the right inner quarter panel above the right rear wheel housing. The module is concealed beneath the quarter inner trim panel. Concealed within the molded plastic park assist module housing is a microprocessor and the other electronic circuitry of the module. The module housing is sealed to enclose and protect the internal electronic circuitry. The module software is flash programmable. Two connector receptacles (1) containing terminal pins are integral to the forward-facing side of the housing. The module is connected to the vehicle electrical system through two dedicated take outs and connectors of the body wire harness. For more information on how the park assist module operates, Park Assist Module - Operation. The park assist module cannot be adjusted or repaired and, if damaged or ineffective, it must be replaced, Park Assist Module - Removal for more information.