‹

Wheel Speed Sensor

Sensors and Switches › Sensors and Switches - Brakes and Traction Control
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartFront Speed Sensor
ManufacturerCHY
OEM part #68004019AD
Price$28.70
PartRear Speed Sensor
ManufacturerCHY
OEM part #52125003AB
Price$25.95

Labor

Replace — Front Speed Sensor — One Side0.8 hr
Warranty 0.0 hrSkill B
Rear Speed Sensor — One Side0.6 hr
Warranty 0.0 hrSkill B
Procedures
Wheel Speed Sensor - Installation — Rear5 steps
ℹ NOTE
Make sure the connector locking tab is fully engaged and locked in position.
Fig. 1
Fig. 1
  1. Insert the wheel speed sensor through the support plate.
  2. Tighten the wheel speed sensor bolt (2) to 9 Nm (80 in. lbs.).
  3. Secure the wheel speed sensor wire to the routing clips. Verify that the sensor wire is secure and clear of the rotating components.
  4. Reconnect the wheel speed sensor electrical connector (1).
  5. Lower the vehicle.
Wheel Speed Sensor - Installation — Front7 steps
ℹ NOTE
When installing, do not rotate sensor, as this may cause the sensor to rub on the tone ring and be damaged.
Fig. 1
Fig. 1
  1. Install the wheel speed sensor to the vehicle.
  2. Install the wheel speed sensor (1) through the brake shield and to the hub/bearing (3).
  3. Install the wheel speed sensor wire hold down routing clips.
  4. Install the wheel speed sensor mounting bolt (2) to the hub (3). Tighten the mounting bolt to 8 Nm (71 in. lbs.).
  5. Install the disc brake rotor Brake Rotor - Installation.
  6. Install the disc brake caliper adapter. Disc Brake Caliper Adapter - Installation.
  7. Install the tire and wheel assembly Service and Repair.
Wheel Speed Sensor - Removal — Rear5 steps
Fig. 1
Fig. 1
  1. Raise and support the vehicle.
  2. Disengage the locking tab connector (1).
  3. Disconnect the wheel speed sensor electrical connector (1).
  4. Remove the wheel speed sensor mounting bolt (2) from the rear support plate.
  5. Remove the wheel speed sensor from the support plate.
Wheel Speed Sensor - Removal — Front9 steps
△ CAUTION
Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.
Fig. 1
Fig. 1
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the caliper adapter. Disc Brake Caliper Adapter - Removal.
  4. Remove the disc brake rotor. Brake Rotor - Removal.
  5. Remove the wheel speed sensor mounting bolt (2) to the hub (3).
  6. Remove the wheel speed sensor wire (1) from the hub/bearing and through the brake shield.
  7. Remove the wheel speed sensor wire hold down clips.
  8. Remove the locking connector at the wheel liner from the sensor connector.
  9. Remove the wheel speed sensor from the vehicle.