‹

Horn Switch

Sensors and Switches › Sensors and Switches - Lighting and Horns
Unified entry — merged from multiple cross-listed pages in the original manual.

Labor

Replace0.5 hr
Warranty 0.0 hrSkill B
Procedures
Horn Switch - Installation5 steps
⚠ WARNING
On vehicles equipped with airbags, refer to electrical, restraints before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible serious or fatal injury.
ℹ NOTE
The horn switch pads are only serviced as an assembly with the airbag mounting bracket.
Fig. 1
Fig. 1
  1. Position the airbag mounting bracket (3).
  2. Press down to compress the springs and install the four e-clip retainers (4), securing bracket to the airbag (1).
  3. Position the airbag assembly and connect the electrical connectors (2).
  4. Install the driver side airbag assembly,Driver Air Bag - Installation.
  5. Connect the battery negative cable.
Horn Switch - Removal3 steps
⚠ WARNING
On vehicles equipped with airbags, refer to electrical, restraints before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible serious or fatal injury.
ℹ NOTE
The horn switch pads are only serviced as an assembly with the airbag mounting bracket.
Fig. 1
Fig. 1
  1. Remove the driver side airbag assembly (1). Driver Air Bag - Removal.
  2. Disconnect the electrical connectors (2).
  3. Remove the four e-clip retainers (4) that secure the airbag mounting bracket (3) to the airbag.