‹

Steering Wheel

Steering and Suspension › Steering
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartWithout Arctic Package
ManufacturerCHY
OEM part #1TT661DFAB
Price$440.00
NotesOrder By Color.
PartWith Arctic Package
ManufacturerCHY
OEM part #1XT461DVAA
Price$492.00
NotesOrder By Color.
PartWith Speed Control
ManufacturerCHY
OEM part #1XT571KAAA
Price$375.00
NotesOrder By Color.

Labor

Replace0.4 hr
Warranty 0.0 hrSkill B
Procedures
Installation3 steps
ℹ NOTE
Do not reuse the old steering wheel bolt (a new bolt must be used)
ℹ NOTE
Be certain that the steering wheel mounting bolt is tightened to the proper torque specification to ensure proper clockspring operation.
  1. Install steering wheel to the column
  2. Install the new steering wheel bolt. Tighten the bolt to 54 Nm (40 ft. lbs.).
  3. Install the drivers side air bag. Driver Air Bag - Installation.
Removal4 steps
ℹ NOTE
Ensure the puller jaws (1) are seated in the pockets of the steering wheel armature.
Fig. 1
Fig. 1
Fig. 2
Fig. 2
  1. Disable and remove the drivers side airbag.Driver Air Bag - Removal.
  2. Partially remove the steering wheel bolt and leave the bolt in the column.
  3. Install puller special tool puller (2) with OTC(R) 7929A jaws (1) or equivalent using the top of the bolt (3) to push on.
  4. Remove the steering wheel.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
STEERING WHEEL📷 1
1. Disable and remove the drivers side airbag. Refer to REMOVAL . 2. Partially remove the steering wheel bolt and leave the bolt in the column.
3. Install puller special tool L-4407A puller (2) with OTC® 7929A jaws (1) or equivalent using the top of the bolt (3) to push on.
NOTE: Ensure the puller jaws (1) are seated in the pockets of the steering wheel armature.
4. Remove the steering wheel.
figure
STEERING WHEEL📷 1
NOTE: Do not reuse the old steering wheel bolt (a new bolt must be used)
1. Install steering wheel to the column
NOTE: Be certain that the steering wheel mounting bolt is tightened to the proper torque specification to ensure proper clockspring operation.
2. Install the new steering wheel bolt. Tighten the bolt to 54 N.m (40 ft. lbs.). 3. Install the drivers side air bag. Refer to INSTALLATION .
GEAR
figure