‹

Parking Brake Lever

Brakes and Traction Control › Parking Brake System
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Parking Brake Lever - Installation9 steps
Fig. 1
Fig. 1
  1. Install the parking brake lever assembly (3).
  2. Install the parking brake lever assembly (3) to the mounting bolts and tighten the nuts (1) to 16 Nm (140 in. lbs.).
  3. Engage the front cables to the equalizer.
  4. Reconnect the parking brake lamp switch wire (2).
  5. If installing a new parking brake lever remove the pin that comes on the lever when shipped.
  6. If you are reinstalling the original park brake lever remove the lock out device at this time.
  7. Install the occupant restraint controller Occupant Restraint Controller - Installation.
  8. Test the parking brake lever.
  9. Install the center floor console, Service and Repair.
Parking Brake Lever - Removal7 steps
Fig. 1
Fig. 1
  1. Remove the center floor console, Service and Repair.
  2. Lock out the parking brakesProcedures.
  3. Disengage the front cables from the equalizer.
  4. Disconnect the parking brake lamp switch wire (2).
  5. Remove the occupant restraint controller mounting nuts (4) Occupant Restraint Controller - Removal
  6. Remove the parking brake lever assembly mounting nuts (1).
  7. Remove the lever assembly (3).
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
PARKING BRAKE LEVER📷 1
Lever Assembly & Occupant Restraint Controller Mounting Nuts
  1.   Remove the center floor console. Refer to REMOVAL .
  2.   Lock out the parking brakes. See ADJUSTMENTS.
  3.   Disengage the front cables from the equalizer.
  4.   Disconnect the parking brake lamp switch wire (2).
  5.   Remove the occupant restraint controller mounting nuts (4). Refer to REMOVAL .
  6.   Remove the parking brake lever assembly mounting nuts (1).
  7.   Remove the lever assembly (3).
figure
PARKING BRAKE LEVER📷 2
Lever Assembly & Occupant Restraint Controller Mounting Nuts
1. Install the parking brake lever assembly (3). 2. Install the parking brake lever assembly (3) to the mounting bolts and tighten the nuts (1) to 16 N.m (140 in. lbs.). 3. Engage the front cables to the equalizer. 4. Reconnect the parking brake lamp switch wire (2). 5. If installing a new parking brake lever remove the pin that comes on the lever when shipped. 6. If you are reinstalling the original park brake lever remove the lock out device at this time. 7. Install the occupant restraint controller. Refer to INSTALLATION . 8. Test the parking brake lever. 9. Install the center floor console. Refer to INSTALLATION .
SHOES
figure
figure