‹

Accelerator Pedal

Powertrain Management › Fuel Delivery and Air Induction
Unified entry — merged from multiple cross-listed pages in the original manual.
Procedures
Installation6 steps
ℹ NOTE
If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
Fig. 1
Fig. 1
  1. Position the accelerator pedal/APPS assembly over the two mounting studs.
  2. Install two accelerator pedal mounting bracket nuts (2) and tighten to 12 Nm (9 ft. lbs.).
  3. Connect the accelerator pedal electrical connector (3) to the APPS.
  4. Use a scan tool to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
  5. If necessary, also use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from the PCM.
  6. Before starting the engine, operate the accelerator pedal to check for any binding.
Removal3 steps
Fig. 1
Fig. 1
  1. Disconnect electrical connector (3) at APPS.
  2. Remove two accelerator pedal mounting bracket nuts (2).
  3. Remove accelerator pedal/APPS assembly (1) from vehicle.
Factory service manual
From the 2008 KK factory manual — descriptions, specs, torque & procedures for this part.
ACCELERATOR PEDAL - WITHOUT ACCELERATOR PEDAL POSITION SENSOR📷 1
The accelerator pedal and APPS (Accelerator Pedal Position Sensor) are serviced as a complete assembly including the bracket.
1. Disconnect electrical connector (3) at APPS. 2. Remove two accelerator pedal mounting bracket nuts (2). 3. Remove accelerator pedal/APPS assembly (1) from vehicle.
figure
ACCELERATOR PEDAL - WITHOUT ACCELERATOR PEDAL POSITION SENSOR📷 1
The accelerator pedal and APPS (Accelerator Pedal Position Sensor) are serviced as a complete assembly including the bracket.
  1.   Position accelerator pedal/APPS assembly over two mounting studs.
  2.   Install two accelerator pedal mounting bracket nuts (2).
  3.   Connect electrical connector (3) at APPS.
  4.   Before starting engine, operate accelerator pedal to check for any binding.
figure
ACCELERATOR PEDAL - WITHOUT ACCELERATOR PEDAL POSITION SENSOR📷 1
The accelerator pedal and APPS (Accelerator Pedal Position Sensor) are serviced as a complete assembly including the bracket.
1. Disconnect electrical connector (3) at APPS. 2. Remove two accelerator pedal mounting bracket nuts (2). 3. Remove accelerator pedal/APPS assembly (1) from vehicle.
figure
ACCELERATOR PEDAL - WITHOUT ACCELERATOR PEDAL POSITION SENSOR📷 1
The accelerator pedal and APPS (Accelerator Pedal Position Sensor) are serviced as a complete assembly including the bracket.
  1.   Position accelerator pedal/APPS assembly over two mounting studs.
  2.   Install two accelerator pedal mounting bracket nuts (2).
  3.   Connect electrical connector (3) at APPS.
  4.   Before starting engine, operate accelerator pedal to check for any binding.
INJECTOR-FUEL
figure