Detailed components
🔧
Accelerator Pedal
2 procedures
🔧
Fuel Filler Cap
2 procedures
🔧
Fuel Filler Neck
2 procedures
🔧
Fuel Gauge Sender
4 procedures · Labor
🔧
Fuel Injector
3 procedures · Parts · Labor
🔧
Fuel Line Coupler
2 procedures
🔧
Fuel Pump
3 procedures · Parts · Labor
🔧
Fuel Rail
2 procedures · Parts · Labor
🔧
Fuel Tank
3 procedures · Parts · Labor
🔧
Fuel Tank Shield
2 procedures
🔧
Throttle Body
2 procedures · Parts · Labor
Quick reference
Fuel Delivery Special Tools
1 procedure
Fuel Delivery Special Tools
SPECIAL TOOLS Special Tools:
Fuel Delivery and Air Induction
1 procedure · Labor
Labor
Service or Charge — System, Service3.1 hr
Fuel System Torque Specifications
SPECIFICATIONS
Fuel Injector O-Ring
Labor
Labor
Replace — One1.1 hr
All1.4 hr
Fuel Pressure Regulator
Labor
Labor
Replace1.4 hr
Fuel Return Line
1 procedure
Fuel Return Line: Description and Operation
⚠ WARNING
The fuel system may be under a constant pressure (even with the engine off). Before servicing any fuel system hoses, fittings, lines, or most components, fuel system pressure must be released. Refer to the fuel system pressure release procedure.DESCRIPTION Service and Repair The lines/tubes/hoses used on fuel injected vehicles are of a special construction. This is due to the higher fuel pressures and the possibility of contaminated fuel in this system. If it is necessary to replace these lines/tubes/hoses, only those marked EFM/EFI may be used. If equipped: The hose clamps used to secure rubber hoses on fuel injected vehicles are of a special rolled edge construction. This construction is used to prevent the edge of the clamp from cutting into the hose. Only these rolled edge type clamps may be used in this system. All other types of clamps may cut into the hoses and cause high-pressure fuel leaks. Use new original equipment type hose clamps.
Fuel Supply Line
1 procedure
Fuel Supply Line: Description and Operation
⚠ WARNING
The fuel system may be under a constant pressure (even with the engine off). Before servicing any fuel system hoses, fittings, lines, or most components, fuel system pressure must be released. Refer to the fuel system pressure release procedure.DESCRIPTION Service and Repair The lines/tubes/hoses used on fuel injected vehicles are of a special construction. This is due to the higher fuel pressures and the possibility of contaminated fuel in this system. If it is necessary to replace these lines/tubes/hoses, only those marked EFM/EFI may be used. If equipped: The hose clamps used to secure rubber hoses on fuel injected vehicles are of a special rolled edge construction. This construction is used to prevent the edge of the clamp from cutting into the hose. Only these rolled edge type clamps may be used in this system. All other types of clamps may cut into the hoses and cause high-pressure fuel leaks. Use new original equipment type hose clamps.
Special Tools
1 procedure
Special Tools
SPECIAL TOOLS Special Tools:
Throttle Body Gasket
Parts · Labor
Parts
PartGasket
ManufacturerCHY
OEM part #4666113AC
Price$12.25
Labor
Replace0.4 hr