‹

Wheel Bearing

Transmission and Drivetrain › Drive Axles, Bearings and Joints
Unified entry — merged from multiple cross-listed pages in the original manual.

Parts

PartFront Hub & Bearing
ManufacturerCHY
OEM part #52109947AF
Price$162.00
PartAxle Bearings
ManufacturerCHY
OEM part #52111197AB
Price$24.85

Labor

Replace — Front Suspension — Front Hub & Bearing — One Side1.0 hr
Warranty 0.0 hrSkill B
Rear Axle — Axle Bearings — One Side1.2 hr
Warranty 0.0 hrSkill B
Procedures
Front Hub And Bearing - Removal8 steps
△ CAUTION
Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.
Fig. 1
Fig. 1
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the caliper adapter Disc Brake Caliper - Removal.
  4. Remove the disc brake rotor Brake Rotor - Removal.
  5. Remove the wheel speed sensor Front.
  6. Remove the axle shaft nut. (if equipped with four wheel drive)
  7. Remove the three mounting bolts (1) for the hub/bearing assembly.
  8. Remove the hub/bearing.
Front Hub And Bearing - Installation7 steps
Fig. 1
Fig. 1
  1. Install the hub/bearing assembly to the vehicle.
  2. Install the three mounting bolts (1) for the hub/bearing. Tighten the bolt to 130 Nm (96 ft.lbs.).
  3. Install the axle shaft nut. Tighten the nut to 135 Nm (100 ft.lbs.). (if equipped with four wheel drive)
  4. Install the wheel speed sensor to the hub. Tighten the bolt to 13.5 Nm (10 ft.lbs.) Front.
  5. Install the disc brake rotor Brake Rotor - Installation.
  6. Install the disc brake caliper adapter. Tighten the nut to 135 Nm (100 ft.lbs.) Brake Rotor - Installation.
  7. Install the tire and wheel assembly. Service and Repair.
Steering/Suspension - Wheel Hub/Bearing Inspection COLL.reference
NUMBER: 31-001-12 GROUP: Collision Bulletin DATE: January 11, 2012 SUBJECT: Wheel Bearing and Hub Replacement/inspection Guidelines During Collision Repairs OVERVIEW: This bulletin involves wheel bearing and hub replacement/inspection during collision repairs. DISCUSSION: During a collision repair where suspension damage has occurred from direct impact to a wheel, the wheel bearing and hub will be addressed as follows: ^If there is damage to the steering knuckle or control arm(s) and ball joints, the bearing and hub are to be replaced. ^If there is damage to suspension or steering components, wheel(s), or the cradle, other than the steering knuckle or control arm(s) and ball joints mentioned above, the wheel bearing and hub should be inspected and replaced if any concern exists. POLICY: Information Only. Disclaimer: This bulletin is supplied as technical information only and is not an authorization for repair.